Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 80
2-50
IM 04L31A01-17E
2.14 Processing during Recovery of the DO/Internal
Switch Communication Buffer
Set the operation to be performed for recovery of the control output DO/internal switch
communication buffer when turning the power ON, or when returning to operation mode
from basic setting mode. The communication buffer is the internal area that stores the
DO/internal switch ON/OFF setting status through communications.
Continue [1]:
Holds the status of the control output DO and internal switches
Clear:
Clears the status of the control output DO and internal switches
Procedure
1.
Press the MENU key.
The setting mode (control) display appears.
2.
Press the FUNC key for approximately 3 s.
The basic setting menu appears.
3.
Press the [#7] (Communication) soft key ([#9] (Communication) soft key on the
CX1000).
Communication setting menu appears.
4.
Press the [#5] (AUX) soft key ([#9] (AUX) soft key on the CX1000).
Communication (AUX) setting display appears.
5.
Use the arrow keys to move the cursor to the [DO/SW] box.
6.
Press the [Continue] or [Clear] soft key.
Confirming or Canceling the Settings
7.
To confirm the new settings, press the DISP/ENTER key. To cancel the
settings, press the ESC key.
For a detailed procedure in confirming or canceling settings, see “Setup Procedure Using
Operation Keys” on page ix.
Saving the Settings
8.
Press the ESC key several times to display the basic setting menu.
9.
Press the [End] soft key. A dialog box appears for you to select whether to save
the settings.
10.
To save the settings, select [Yes]. To not save the settings, select [No]. To
return to the basic setting menu, select [Cancel]. Then, press the DISP/ENTER
key.