Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 66)

2-36
IM 04L31A01-17E
Zooming in or out of the Display
7. Click [Zoom] to specify [100%] or [75%] ([200%] on the CX1000).
Displaying the Alarm Summary
8. Click [Alarm Summary] in the display menu section to display the alarm
summary.
Click [Refresh] to refresh the alarm summary information.
Click [Close] to close the alarm summary window.
Displaying Measurement/Computation Channel Information or Control Channel
Information
9. Click [Meas-Math Channels] or [Control Channels] in the display menu section
to display the measured/computed data or control data, respectively.
Click [Refresh] to refresh the measured/computed/control data.
Click [Close] to close the measured/computed/control data window.
Displaying the Log
10. Click [Log] in the display menu section to display the log.
Click the box used to select the log type. The selected type of log is displayed.
Click [Refresh] to refresh the log information.
Click [Close] to close the log window.
Using the Operator Page
This section gives an overview of the operations. Follow the operating procedures on
your PC.
Procedure
1. Start the Web browser and open the operator page of the CX.
Note
Operator page can be displayed when the CX is in the operation mode. An error message is
displayed when the CX is in the setting mode or basic setting mode. For details on the operation
mode, setting mode and basic setting mode, see the
user’s manual IM 04L31A01-01E or IM
04L31A01-03E .
The following operations are the same as the monitor page. See “Using the Monitor Page.”
Entering the User Name and Password
Auto Refreshing the Display
Refreshing the Display Manually
Zooming in or out of the Display
Displaying the Alarm Summary
Displaying Measured/Computed Data
Displaying the Log
Operations Only on the Operator Page
• Setting/Modifying and writing messages
[Message] in the display menu section appears only when the use of command input
is enabled in the operator page settings.
11. Click [Message] in the display/operation menu section to display the Active
Message window.
2.10 Using the Monitor Page and Operator Page