Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 37)

2-7
IM 04L31A01-17E
Ethernet Interface
2
21. Enter the address of the primary DNS server in the dialog box.
22. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The address that you entered is displayed in the [Primary] box.
• Setting the Secondary DNS Server Address
Enter the information if the system or network to which the CX belongs uses a
secondary DNS server. If this is not necessary, proceed to step 25.
23. Use the arrow keys to move the cursor to the [Secondary] box.
24. Set the address of the secondary DNS server in a similar fashion as described
in steps 20 to 22.
• Setting the Host Name of the CX
25.
Use the arrow keys to move the cursor to the [Host name] box.
26. Press the [Input] soft key. An entry box appears.
27. Enter the host name of the CX in the entry box.
28. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The host name address that you entered appears in the [Host name] box.
• Setting the Domain Name to Which the CX Belongs
29.
Use the arrow keys to move the cursor to the [Domain name] box.
30. Press the [Input] soft key. An entry box appears.
31. Enter the domain name of the CX in the entry box.
32. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The domain name address that you entered appears in the [Domain name] box.
• Setting the Primary Domain Suffix
Set this parameter if you require the domain suffix. If this is not necessary,
proceed to step 39.
33. Use the arrow keys to move the cursor to the [Primary] box under Domain suffix
search order.
34. Press the [Input] soft key. An entry box appears.
2.3 Configuring of the Ethernet Interface