Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 245)

9-12
IM 04L31A01-17E
21. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The characters that you entered are displayed in the respective boxes.
To clear the characters that you entered, press the [Clear] soft key.
To copy the characters, press the [Copy] soft key. The [Paste] soft key appears.
The copied characters can be pasted to boxes in which characters are entered.
Executing Auto Reading
(Applicable only to UT Series.)
22. Use the arrow keys to move the cursor to the [Auto reading] box.
23. Press the [Execute] soft key.
The setup information of the connecting model is read automatically.
Note
The [Execute] soft key is used read the setup information of the connecting model automatically.
Use caution, because the preexisting data will be overwritten.
Setting (Correcting) the Read Data
(Perform the following procedures only if parameters need to be corrected.)
24. Enter the following parameters according to the selected connecting model.
Decimal point position of PV (process value), SP (setpoint), and OUT (control
output).
Unit of PV (process value), SP (setpoint), and OUT (control output).
High and low Limits of the control span
9.4 External Loop Setting > Basic Setting