Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 139)

6-10
IM 04L31A01-17E
Command Command Function Execution mode ADMINISTRATOR USER Page
Type Name
External Loop Setting (Basic Setting)
GJ Specifies external loop Basic setting mode Yes No 6-52
GK External loop parameter auto reading Basic setting mode Yes No 6-52
execute command
GV External loop parameter 4, parameter type/ Basic setting mode Yes No 6-52
decimal point position and unit
GH External loop parameter 1, control span Basic setting mode Yes No 6-53
lower/upper limit
GQ External loop parameter 3, control mode/ Basic setting mode Yes No 6-53
control output type
GN External loop parameter 2, alarm number/ Basic setting mode Yes No 6-53
alarm type
External Loop Setting (Parameter Address Setting)
GW Sets the external loop parameter address Basic setting mode Yes No 6-53
Yes: Command usable
No: Command not usable
Control Commands
Command Command Function Execution mode ADMINISTRATOR USER Page
Type Name
Control Commands
CA Switches between auto, manual, and
cascade control Operation mode Yes No 6-54
OC Switches run/stop Operation mode Yes No 6-54
RL Switches remote/local Operation mode Yes No 6-54
OS Stops/Starts control operation Operation mode Yes No 6-54
(common to all loops)
SN Switches target setpoint number Operation mode Yes No 6-54
PX Resets/Runs program Operation mode Yes No 6-54
HU Holds program operation Operation mode Yes No 6-54
AD Advances program operation Operation mode Yes No 6-54
PN Switches the pattern number Operation mode Yes No 6-54
HJ Changes the manual output setting Operation mode Yes No 6-54
HV Requests auto tuning Operation mode Yes No 6-54
Yes: Command usable
No: Command not usable
Output Commands (Measurement)
Command Command Function Execution mode ADMINISTRATOR USER Page
Type Name
Control
BO Sets the byte output order. All modes Yes Yes 6-55
CS Sets the check sum (usable only during All modes Yes Yes 6-55
serial communications)
IF Sets the status filter All modes Yes Yes 6-55
CC Disconnects Ethernet connection (usable All modes Yes Yes 6-55
only during Ethernet communications)
6.2 A List of Commands