Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 68)

2-38
IM 04L31A01-17E
2.11 Setting the E-mail Transmission Function
Explanation
To use the e-mail transmission function, set the following parameters in addition to those
described in section 2.3.
Basic Settings of E-mail
• SMTP* server name
If the DNS is specified (see section 2.3), you can set the SMTP server name using up
to 64 alphanumeric characters. You can also set the IP address of the SMTP server.
* Simple Mail Transfer Protocol
• Port number
Set the port number to be used. The initial value is 25.
• Recipient 1
Set the recipient of the e-mail message using up to 150 alphanumeric characters.
You can specify multiple addresses by delimiting the addresses using spaces.
• Recipient 2
Set the recipient of the e-mail message using up to 150 alphanumeric characters.
You can specify multiple addresses by delimiting the addresses using spaces.
• Sender
Set the e-mail address that has been provided by the network administrator using
up to 64 alphanumeric characters. If omitted, the sender is set to the first address
specified as the recipient.
Settings for Transmitting Alarm Information
The alarm information is sent when either the control or measurement alarm occurs.
• Recipient 1, Recipient 2
You can turn On/Off the function for each recipient.
• On
Transmits e-mail messages to the recipient.
• Off
Does not transmit e-mail messages to the recipient.
• Alarm number for sending the alarm information via e-mail (alarm 1, alarm 2,
alarm 3, and alarm 4)
You can turn On/Off the function for each alarm number. This setting applies to all
channels.
• On
If the status of any one of the alarms assigned to the alarm number changes
(alarm occurrence or release), an e-mail message is transmitted.
• Off
The alarm information of the alarm number is not transmitted.
• Contents of the transmitted mail
• Including instantaneous values
• On
The instantaneous values of all channels are included in the e-mail message.
• Off
The instantaneous values are not included in the e-mail message.
• Including the source URL (Uniform Resource Locator)
• On
If the Web server function is specified on the CX, the URL of the CX is
attached to the e-mail.
• Off
The URL of the CX is not attached to the e-mail.