Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 266)

App-7
IM 04L31A01-17E
App
Appendix
Example in Which the FIFO Acquisition Interval on the CX Is Set to 1 s and the
Measured/Computed/Control Data from CH1 to CH248 Is Continuously Output using
the FIFO Function (Logging)
BINARY header
BINARY data
BINARY footer
FFRESET
YES
NO
END
Send command
Stop measurement?
Receive response
E0
FFGET,1,60
Send command
Receive response
Wait for the FIFO
acquiring interval (1 s)
Move the FIFO read position to the most recent
acquire position.
Command description
Command to send
Received response data
Output the measured/computed data using the FIFO.
START
BINARY (see section 7.1, “BINARY Output,” or section 7.3,
“Measured/Computed/Control Data and FIFO Data.”)
Note
• The FIFO acquisition interval must be set using the FR command beforehand.
• The FIFO acquisition interval applies to both serial and Ethernet communications.
Appendix 4 Output Flow of FIFO Data