Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 134)

6-5
IM 04L31A01-17E
Command
6
Command Command Function Execution mode ADMINISTRATOR USER Page
Type Name
Event Setting
ET Sets the time event Operation mode Yes No 6-21
EP Sets the PV event Operation mode Yes No 6-22
Event Output Setting
EO Sets the event output Operation mode Yes No 6-22
PA Program pattern end signal Operation mode Yes No 6-22
Repeat Action Setting
PR Sets the repeating action Operation mode Yes No 6-22
Program End
PE End programming Operation mode Yes No 6-22
Auto message for program Run/Reset
PK Set the auto message for program run/reset Operation mode Yes No 6-22
Program display position
PL Set the program display position Operation mode Yes No 6-22
Auto change to program run display
MQ Auto change to program run display Operation mode Yes No 6-22
Event display group
PV Set the event display group Operation mode Yes No 6-22
Detail Settings (Control Function Settings)
HF Sets the setpoint Operation mode Yes No 6-23
GL Sets the output velocity limiter Operation mode Yes No 6-23
GA Sets the anti-reset windup function Operation mode Yes No 6-23
Detail Settings (Hysteresis (Alarm, PV Event))
AP Sets the alarm hysteresis Operation mode Yes No 6-23
PH Sets the PV event hysteresis Operation mode Yes No 6-23
Detailed settings (DIO operation monitoring and function settings)
DX Set the DIO operation monitoring function Operation mode Yes No 6-23
DY Set the DIO operation monitoring function Operation mode Yes No 6-24
tag and tag comment
DZ Set the DIO operation monitoring function Operation mode Yes No 6-24
label and display color
Detailed settings (DI/DO label settings)
DW Set the DI/DO label Operation mode Yes No 6-24
Control computation
MT Se the equation Operation mode Yes No 6-25
MU Se the computation error Operation mode Yes No 6-25
MV Se the logic computation Operation mode Yes No 6-25
MX Se the computation constant Operation mode Yes No 6-25
DU Se the remote bias Operation mode Yes No 6-25
External Loop Setting (PID Parameter)
DT Sets the external loop PID parameter Basic setting mode Yes No 6-26
External Loop Setting (Control Parameter)
DV Sets the external loop control parameter Basic setting mode Yes No 6-26
Yes: Command usable
No: Command not usable
6.2 A List of Commands