Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 118)

2-1
IM 04L31A01-01E
Installation and Wiring
3
2
1
4
5
6
7
8
9
10
11
12
13
14
Chapter 2 Installation and Wiring
2.1 Handling Precautions
This section describes the precautions to be taken when using the CX2000 and the
external storage medium. Make sure to read this section before using the CX2000.
Handling Precautions
• This instrument uses many plastic parts. When cleaning, wipe using a dry soft cloth.
Do not use volatile chemicals since this might cause discoloring and deformation.
• Do not bring charged objects near the signal terminals. Doing so can lead to
malfunction.
• Do not pour volatile agents on the LCD, panel keys, or other parts of the instrument
nor leave them in contact with rubber or PVC products for an extended time. Doing
so can lead to malfunction.
• Do not apply shock to the instrument.
• When not in use, make sure to turn OFF the power.
• If there are any symptoms of trouble such as smoke, strange ordors, or strange
sounds coming from the instrument, immediately turn OFF the power and disconnect
power supply. Then, contact your nearest YOKOGAWA dealer or representative.
Handling Precautions for the External Storage Medium
• Use caution in the handling of the external storage medium as it is delicate.
• Write operations to floppy disks and Zip disks may fail in high-temperature or low-
temperature environments. If you are using the CX2000 in a low-temperature
environment (around 10 °C or less), use the CX2000 after the warm-up time (at least
30 minutes) has elapsed.
If you are using the CX2000 in a high-temperature environment (around 40 °C or
more), it is recommended that the external storage medium be inserted into the drive
when saving the data and be removed after the data storage operation is finished.
• If you are using a commercially available compact flash card on CX2000s in the ATA
flash memory card drive, be careful of static electricity. The CX2000 may not operate
properly if you touch the compact flash card that is inserted into the CX2000 when
your body is charged with static electricity.
• Handling the CF Card and Adapter
Insert the CF card into the adapter as shown in the figure below. The card should
remain in the adapter when removing it from the card slot on the CX2000.
CF card
Do not force the CF card when inserting it into the adapter. If the card
does not seem to fit, make sure you are inserting it right-side up.
Adaptor
Insert the card until these
edges are nearly flush.
• For the general handling precautions of the external storage medium, see the
instruction manual that came with that medium.
CAUTION
• If you turn ON/OFF the CX2000 while a Zip disk is inserted in the drive, the Zip
drive may malfunction. When turning ON/OFF the CX2000, first remove the Zip
disk from the drive.
• Do not eject the external storage medium while the access lamp is illuminated.
This can damage the data.
• Do not operate the floppy disk drive or Zip drive in a place with vibrations or
shock. The disk or drive may malfunction.