Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 215)

5-6
IM 04L31A01-01E
5.5 Program parameter setting > Program pattern
setting
This section explains the procedures for setting the program pattern items such as the
target SP of the ramp segment during program control.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #1 soft key (select [Program parameter setting])> #4 soft key
(select [Program pattern setting])
Move to the event setting display
Increment/Decrement the segment number
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Note
You can change the patterns even when program control is in progress. However, setting
changes are not applied to the segment that is currently being executed. In addition, you
cannot increase or decrease the number of segments or change the segment setting method
of the pattern that is in use by program control.
Setup Items
Program pattern setting
• Pattern number
Displays the pattern number selected in the pattern initial settings.
• Segment number
Select the number of the segment to be changed from 1 to 99 (within the number of
used segments).
• Ramp/Soak select
Select the type of segment to be specified ([Ramp] or [Soak]).