Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 320)

11-6
IM 04L31A01-01E
3. If “UserID Use/Not” is set to “Use” in the key login settings, a User ID entry window
appears. Enter the User ID and press the DISP/ENTER key .
4. A password entry window appears. Enter the Password and press the DISP/
ENTER key .
If the password is correct, the user is logged in, and the user name appears in the
status indication section as shown below.
Note
When starting/stopping the acquisition of the display data/event data to the internal memory,
the user name is written to the respective files. The user name when writing messages is
also written to the internal memory.
Logout Operation
• Manual Logout
1. Press the FUNC key .
The soft key menu is displayed.
2. Press the [Logout] soft key .
The user name in the status indication section disappears.
• Auto logout
If the auto logout function is enabled, users are automatically logged out when
there is no key operation for 10 minutes in operation mode.
Note
If the CX2000 is switched from basic setting mode to operation mode, the CX2000 is in a
logged out condition.
Setup Items
Setting Key Login
• Use/Not
To enable the key login function select [Use].
• Auto logout
On: Automatically logs the user out if there is no key operation for ten minutes.
Off: The user stays logged on until the user manually logs out.
• UserID Use/Not
Set whether to use the User ID when logging in ([Use/Not]). If [Use] is selected, the
[User ID] entry box appears.
• Number
Select the user registration number from [1] to [7].
• Off/On
Select whether to enable [On] or disable [Off] the key login function of the user
corresponding to the registration number.
11.3 Key Operation Login/Logout