Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 243)

6-18
IM 04L31A01-01E
GROUP PV events
Time events
One part event names
One part
event names Event names
Executing Several Program Patterns
You can execute multiple program patterns whose loop numbers do not overlap.
Switching Pattern Numbers (see page 6-13)
1. Press the [PT NO.] soft key in the program selection screen.
The pattern number switching pop-up window appears. The currently set
pattern numbers are displayed in the window.
2. Select a pattern number using the up and down arrow keys .
3. Press DISP/ENTER key to confirm the changed settings.
To close without saving, press the ESC key.
Program Operation Start
1. Press the [RUN] soft key .
The program operation start pop-up window appears.
2. Press the DISP/ENTER key . The screen changes to the program operation display.
Displaying the Program Selection Display
1. Press the [SEL PNL] soft key .
The screen changes to the program selection display.
Executing a Separate Program Pattern
1. Repeat the above procedure as necessary.
Switching the Displayed Pattern in the Program Operation Display
1. Press the left or right arrow keys to switch the displayed pattern.
Switching from the Screen Selection Menu
1. Press DISP/ENTER key in the program operation display to display the display
selection menu.
2. With Control selected, press the Right arrow key to display a submenu.
3. Press the up and down arrow keys to select the pattern to display.
4. Press the DISP/ENTER key to display the selected pattern.
6.4 Operations on the Program Selection Display and Program Control Display (Only on Models with the
Program Control Option)