Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 171)

4-11
IM 04L31A01-01E
Control Function Related Setup Operations
4
4.3 Control > Output processing
This section describes the procedures for selecting the control output type, cycle time,
and analog output.
To perform ON/OFF control, set [Control output] to [On/Off-control].
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to Set mode) > Hold down the FUNC key for 3 seconds (switch
to basic setting mode) > #10 soft key (select [Control]) #3 soft key (select [Output
processing])
The following setting display appears.
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Note
The [Cycle time] is set using the pop-up window that appears by pressing the [Input] soft key.
Saving the Settings
1. Press the ESC key .
The display returns to basic setting menu.
2. Press the [End] soft key .
A confirmation dialog box appears
3. Select [Yes] and press the DISP/ENTER key .
The operation screen is displayed.