Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 223)

5-14
IM 04L31A01-01E
5.10 AUX (Auto message, Display position)
This section explains the procedures for setting auto message printing during program
control and the display position for each loop on the program control display.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #3 soft key (AUX (Auto message, Display position))
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Setup Items
Auto message for program Run/Reset
• On/Off
If you select [On] (initial setting), a message is automatically written on the trend
display when program control is started and when program control is stopped as
shown in the figure below. If you do not wish to write messages, select [Off]. The
message upon program operation start is “Pattern name top 12 characters + space +
RUN”, and the message upon program operation stop is “Pattern name top 12
characters + space + RST”.