Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 149)

3-8
IM 04L31A01-01E
Selecting Setup Items on the Setting Display
1. Use the
arrow keys to move the cursor (blue) to the appropriate item box.
The soft keys corresponding to the item are displayed at the bottom section of the display.
2. Select the item using the soft key .
The box for the item you entered turns yellow, and the cursor moves to the next item.
To cancel the settings, press the ESC key. On the cancel confirmation window that
appears, press the DISP/ENTER key with [Yes] is selected.
Note
If values or characters need to be entered, the soft key menu displays [Input]. For the
procedure in entering values and characters, see pages 3-9 to 3-10 .
Confirming Settings on the Setting Displays
Press the
DISP/ENTER key .
The item you entered is confirmed and the item box turns white again. The cursor
moves to the first item box on the setting display.
Note
If you attempt to confirm the setting by pressing the key on the setup display invoked by the
[Setting mode (control)] > [Control Input Range] command sequence, a confirmation window
with a message “Do you really want to change the settings?” appears.
Switching from Setting Mode to Operation Mode
Display setting menu and press the
ESC key .
Switching from Basic Setting Mode to Operation Mode and Saving the Basic
Settings
Display basic setting menu, and then carry out the following procedures.
1. Press the
[End] soft key .
A confirmation window containing the message “Do you want to store and make the
new settings take effect?” appears.
2. Select [Yes] using the arrow keys and press the DISP/ENTER key .
The settings are saved and the CX2000 returns to operation mode. If you select [No]
and press the DISP/ENTER key, the settings are not saved and the CX2000 returns
to operation mode. In this case, the settings remain unchanged. Selecting [Cancel]
and pressing the DISP/ENTER key returns you to basic setting mode menu.
3.2 Basic Key Operations