Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 238
6-13
IM 04L31A01-01E
Operations during Control Operation
6
Switching the Pattern Number
1. Press the
[PT NO.] soft key
.
A pop-up window for switching the pattern number appears. The window shows
the current pattern number.
2. Select the pattern number using the up and down arrow keys.
3. Press the
DISP/ENTER
key to confirm the changes.
To close the window without making any changes, press the ESC key.
Setting Operation for Patterns That Start by Communications Command, DI/DO, or
Internal Switches (Style Number S3 Or Later)
1.
Press the
[SET PTNO.] soft key
.
The pattern number (the same number as the pattern number that can be
started from this screen) selected by the PT NO. soft key above is set.
Even if you change the pattern number with the PT NO. soft key, if you do not
press the SET PTNO soft key, the pattern numbers that start by communication
commands, DI/DO/internal switches are not changed.
Switching to the Overview Screen (Style Number S3 or Later)
1.
Press the
[OVERVIEW] soft key
.
Among the loops of the displayed program patterns, the screen switches to the
overview screen including loops with small numbers.
Switching to the Control Group Screen (Style Number S3 or Later)
1.
Press the
[CNTRL GRP] soft key
.
Among the loops of the displayed program patterns, the screen switches to the
group’s control group screen including loops with small numbers.
Selecting Segments
• Press the
left and right arrow keys
.
The displayed pattern waveform shifts horizontally by one segment. The
[SEGMENT NO], [SEGMENT TIME], and the target SPs of each group
corresponding to the segment shown at the left end are displayed.
• To shift 10 segments at a time, press the
[+10SEG]
or
[-10SEG] soft key
.
• Press the
up arrow key
to show the pattern waveform overview window as shown
in the figure below. You can select segments (as described above) while showing
this pattern waveform overview window. To close the pattern waveform overview
window, press the
down arrow key
.
Display of the segment number/segment
time at the left frame line position
Pattern waveform
overview window
Indicates the pattern waveform display
area (move using the left and right
arrow keys) using a rectangular frame
6.4 Operations on the Program Selection Display and Program Control Display (Only on Models with the
Program Control Option)