INFICON IC6 Thin Film Deposition Controller User Manual
Page 175
Advertising
10 - 5
PN
07
4-
50
5-
P1
F
IC6 Operating Manual
Select the button for Use the following IP address, enter the IP address and
Subnet mask shown in
, and press OK. With this selection, the PC is
assigned an IP address to use when communicating with the IC6. The IC6 is
shipped from INFICON with a pre-assigned address of 10.211.72.203. To
communicate directly with the IC6 from a PC, the PC must also be assigned an
address that starts with 10.211.72 but cannot be set to 10.211.72.203. The
example in
uses the address 10.211.72.100 for the PC.
Figure 10-4 Entering the IP address and subnet mask
Click OK to all open dialogs to close out the Internet Protocol setup for the Local
Area Connection.
Advertising