INFICON IC6 Thin Film Deposition Controller User Manual
Page 41
Advertising
1 - 21
PN
07
4-
50
5-
P1
F
IC6 Operating Manual
1
Confirm that AC line voltage is supplied and proper for the IC6.
2
Confirm that the back panel (main) AC switch is in the ON position.
3
Press the ON/STBY button on the front panel. A green pilot light should be seen
next to the power switch.
4
The fan at the back of the IC6 should be exhausting air.
5
After the initial temporary boot-up screen which can be viewed in Maintenance
Sys Status, see
, the LCD monitor will display an
image similar to the one shown in
.
Figure 1-1 Operate Screen
Advertising