Remove/install the him – Rockwell Automation 20D PowerFlex 700S AC Drives with Phase II Control Programming Manual User Manual
Page 160
Advertising
160
Rockwell Automation Publication 20D-PM001C-EN-P - July 2013
Appendix A
Human Interface Module Overview
Remove/Install the HIM
The HIM can be removed or installed while the drive is powered.
Steps:
Key(s):
Example Display:
To remove the HIM…
1. Press ALT and then Enter (Remove). The Remove HIM
configuration screen appears.
2. Press Enter to confirm that you want to remove the
HIM.
3. Remove the HIM from the drive or disconnect the
cable.
To install HIM…
• Insert the HIM into drive or re-connect cable.
ALT
+
Remove Op Intrfc:
Press Enter to
Disconnect Op Intfc?
(Port 2 Control)
Advertising