Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 102)

102 Publication 2711-UM014G-EN-P - September 2008
Chapter 3 Configuring the Terminal
Set Up the Printer Select Printer Setup from the Configuration Mode menu to set
parameters for those terminals equipped with an RS-232 printer port.
Any printer that supports the IBM enhanced character set can be
connected to the RS-232 printer port.
Printer settings are maintained between power cycles.
Page format parameters for printing are defined in the Terminal Setup
dialog of PanelBuilder32 software and downloaded with the
application.
Handshaking
Specifies the type of handshaking used by the RS-232 port.
•
None (initial default)
•
Hardware
•
XON/XOFF
If you change the type of handshaking used, you must reset your
PanelView before the change takes effect.
Communication Parameters
Sets the communication parameters for the printer port. Each key
press toggles through the available combinations for:
•
Parity (None, Even or Odd)
•
Data Bits (7 or 8)
•
Stop Bits (1 or 2)
IMPORTANT
The PanelView 300 Micro terminal does not support printer
functions.
PRINTER SETUP
Handshaking Communication Parameters Baud Rate
XON/XOFF No Parity
8 Data Bits
1 Stop Bit
19200
F1 F2 F3
Port Mode
Top Of Printing
Enabled
F9 F10
Form
F16
EXIT