Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual User Manual
Page 64
64
Publication 2711-UM014G-EN-P - September 2008
Chapter 2 Applying Power and Resetting Terminal
Connect the power source to the terminal at the 3-screw terminal
block (PV300 Micro removable and PV600 Touch only, all others
fixed).
WARNING
Explosion Hazard
•
Substitution of components may impair suitability for Class I,
Class II, Class III, Division 2.
•
Do not replace components or disconnect equipment unless
power has been switched off or the area is known to be
non-hazardous.
•
Do not connect or disconnect components unless power has been
switched off or the area is known to be non-hazardous.
•
This product must be installed in an enclosure. All cables
connected to the product must remain in the enclosure or be
protected by conduit or other means.
•
All wiring must comply with N.E.C. article 501-4(b).