Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 181)

Publication 2711-UM014G-EN-P - September 2008 181
Terminal Connections Chapter 12
EtherNet/IP
xxx20 Ethernet Communication Port
PanelView 550T - 1400
2711-xxx20 to PLC-5E
with
Ethernet cable Use 1756-ENET Module
with
Ethernet cable Use 1761-NET-ENI
Module with Ethernet
cable
Remote I/O
xxx1 Remote I/O Communication Port
PanelView 550T - 1400
2711-xxx1 shielded twinaxial cable
(1770-CD) use 1756-DHRIO Module
with
shielded twinaxial cable
(1770-CD) N/A
DH+
xxx8 DH+ Communication Port
PanelView 550T - 1400
2711-xxx8 shielded twinaxial cable
(1770-CD) use 1756-DHRIO Module
with
shielded twinaxial cable
(1770-CD) N/A
(1)
AIC + Module recommended for isolation purposes when PanelView and controller are not on same power supply
Protocol PanelView Standard Comm Port Cables: PanelView to Processor
PLC-5, PLC-5C, PLC-5E
CH0 (25-pin RS-232)
(DF1) ControlLogix
CH0 (9-pin RS-232)
(DF1) MicroLogix 1000, 1200,
1500LSP
CH0 (8-pin Mini DIN)
(DF1 or DH-485)