Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 154)

154 Publication 2711-UM014G-EN-P - September 2008
Chapter 9 Installing the PV600 Terminal
Enclosures Mount the PV600 terminal in a panel or enclosure to protect the
internal circuitry. The terminal meets NEMA Type 12/13 and 4X
(indoor use) ratings only when mounted in a panel or enclosure with
the equivalent rating.
Allow enough space within the enclosure for adequate ventilation.
Consider heat produced by other devices in the enclosure. The
ambient temperature around the terminals must be between:
•
0…55 °C (32…131 °F) for the PV600 keypad or keypad & touch
screen terminal
•
0…50 °C (32…122 °F) for the PV600 touch screen only terminal
Make provisions to access the back panel of the terminal for wiring,
maintenance, installing a memory card and troubleshooting.
Required Tools Other than the tools required to make the PV600 panel cutout, the
tools required for installation are:
•
small slotted screwdriver
•
torque wrench (lb-in)
•
#2 phillips screwdriver
•
#2 phillips bit for torque wrench