Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 72)

72 Publication 2711-UM014G-EN-P - September 2008
Chapter 3 Configuring the Terminal
Access the Configuration
Mode Menu The Configuration Mode menu appears on powerup if an application
is not loaded or if the menu was last displayed prior to a reset or
power down.
To access Configuration Mode on keypad terminals if an application is
running, simultaneously press the Left and Right arrow keys on
the terminal keypad.
To access Configuration Mode on touch screen terminals:
•
press the GoTo Config. Screen button on application screen or
•
press the filled box in the lower right corner of the screen
during powerup.
Operations List
Select an operation using the Up or Down arrow keys. Press the
Enter
↵
key (keypad terminals) or press (touch screen terminals)
to enter the selection.
Language
Displays the language menu.
TIP
If the Left or Right arrow keys on the PanelView 300
Micro are assigned as function keys, you must use the GoTo
Config. Screen button.
TIP
Most of the screens in this chapter are for the PanelView 900
keypad terminal. The screens for other terminals are similar. On
keypad terminals you press terminal function keys to modify
settings. These keys may differ between terminals depending
on the screen size and function key placement. On touch screen
terminals, you press the screen field or button.
Function keys do not
appear on touch
screen terminals.
On PV550/600 terminals, the Reset Video button is F9. On PanelView
300, 300 Micro terminals, the Reset Video button is F2.
PV300/PV300 Micro Keypad Terminal
Scrolling
List