Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 167)

Publication 2711-UM014G-EN-P - September 2008 167
Installing the PV900/1000 Terminals Chapter 10
Install the
PV900/PV1000 Terminals in
a Panel Follow these steps to install the PV900/PV1000 terminal in a panel.
1. Cut an opening in the panel by using the panel cutout template
provided with the terminal and remove any sharp edges or
burrs.
2. Make sure the terminal sealing gasket is properly positioned on
the terminal, particularly around the mounting studs as shown.
This gasket forms a compression type seal. Do not use sealing
compounds.
Although the keypad legend strip can be installed any time, we
recommend that you install it after the terminal is installed.
3. Place the terminal in the panel cutout.
ATTENTION
•
Disconnect all electrical power from the panel before making the
cutout.
•
Make sure the area around the panel cutout is clear.
•
Do not allow metal cuttings to enter any components that may
already be installed in the panel.
•
Failure to follow this warning may result in personal injury or damage
to the panel components.
Sealing Gasket