Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 268)

268 Publication 2711-UM014G-EN-P - September 2008
Appendix B Messages, Codes and Self-test Numbers
If a test fails, the terminal displays:
ERROR! FEHLER! ERREUR! ERRORE!
The following test numbers appear only if a problem occurs.
The table below shows fault conditions that may occur during
powerup.
25 Firmware not compatible with boot code
26 Firmware not compatible with hardware
30 Watchdog test
31 Stuck key test
32 Real time clock test
33 LCD RAM failed
34 Performed CRC extended firmware check
TIP
You may not see all of these test numbers during a powerup.
Test Number Indicates
40 No executable code to run after boot
50 Wrong memory card format
60 CPU could not execute code
Fault Indicator Indicates
Solid Red Static RAM Test failed. Contact technical support.
Blinking Red
(6 times per second) Checksum test on boot code failed. Contact technical
support.
Blinking Red
(5 seconds on/5 seconds
off) Boot code is incorrect for terminal type (touch screen or
keypad). Contact technical support.
Test Number Indicates