Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 143)

Publication 2711-UM014G-EN-P - September 2008 143
Installing the PV300 Terminal Chapter 7
Install the PV300 Terminal
in a Panel Follow these steps to install the PV300 terminal in a panel.
1. Cut an opening in the panel by using the panel cutout template
provided with the terminal and remove any sharp edges or
burrs.
2. Make sure the terminal sealing gasket is properly positioned on
the terminal, particularly around the mounting studs as shown.
This gasket forms a compression type seal. Do not use sealing
compounds.
3. Verify that the end of the legend strip is fully inserted and does
not interfere with the sealing gasket.
4. Place the terminal in the panel cutout.
5. Verify that the opening is the proper size to clear the bezel and
to allow the gasket to contact the panel.
ATTENTION
•
Disconnect all electrical power from the panel before making the
cutout.
•
Make sure the area around the panel cutout is clear.
•
Do not allow metal cuttings to enter any components that may
already be installed in the panel.
•
Failure to follow this warning may result in personal injury or damage
to the panel components.
Sealing Gasket Legend Strip