Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 82)

82 Publication 2711-UM014G-EN-P - September 2008
Chapter 3 Configuring the Terminal
DeviceNet Communication
The DeviceNet screen lets you display or modify communication
settings for a DeviceNet terminal.
Restart Terminal
Resets the terminal.
New Node Address
Opens the numeric entry scratchpad. Type the node address (0…63)
of the PanelView on the DeviceNet link or enter 64 to use the address
stored on the communication card, Program Mode PGM displayed.
Press the Enter
↵
key to store the address. On touch screen terminals,
press the
↵
key on the scratchpad. A node change takes effect on
reset. If 64 is entered, the node address can be set from the network
using a DeviceNet network configuration tool.
Active Node Address (read only)
Displays the current network operating address of the PanelView
terminal. The default is 63.
IMPORTANT
Settings downloaded with a DeviceNet application take priority
over terminal settings and take effect immediately after the
download.
DeviceNet
New Node Address F2:
Active Node Address:
Input Size:
Output Size:
New Baud F3:
Active Baud:
Bus-off Interrupt F4:
Comms Firmware Revision: Serial Number:
Terminal
Restart
F1 F16
EXIT
125K
125K
ms
Hold in Reset
Mod/Net LED:
Not Connected
2
0
0
500 Interscan Delay F5: