Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 108)

108 Publication 2711-UM014G-EN-P - September 2008
Chapter 4 Using a Memory Card
Load Application
from a Memory Card The procedure below shows how to load an application on a memory
card into the PanelView terminal.
Follow these steps to load an application from a memory card.
1. Insert the memory card in the card slot of the terminal.
If the terminal does not have an application loaded, the
Configuration Mode menu appears. Skip step 2.
2. Open the Configuration Mode menu by simultaneously pressing
the Left and Right arrows (on keypad terminals), or the
Goto Config. Screen button (on touch screen terminals).
3. Select Memory Card and press the Enter
↵
key.
WARNING
Explosion Hazard - Do not install or remove memory card unless
power has been switched off or the area is known to be
non-hazardous.
Function keys do not
appear on touch
screen terminals.