Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 198)

198 Publication 2711-UM014G-EN-P - September 2008
Chapter 12 Terminal Connections
Connecting a Hand-held Terminal
To connect a Hand-held Terminal (HHT) to the PanelView terminal,
use cable Cat. No. 1747-C10. One end of the cable connects to the
HHT connector and the other end connects to the DH-485
programming connector on the terminal. All power is supplied to the
HHT through the cable.
IMPORTANT
The PanelView terminal must be connected to an SLC, DH-485
network, or power supply. This connection provides power for
the HHT.
PanelView 1000 Hand-Held Terminal
Catalog No. 1747-PT1
To DH-485 Programming
Connector
DH-485 Communication Port Must be
connected to an SLC, DH-485 network, or
wallmount power supply (Cat. No. 1747-NP1) to
provide power for the HHT.
Cable, 2 m (6 ft) Cat. No. 1747-C10