Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 251)

Publication 2711-UM014G-EN-P - September 2008 251
Messages, Codes and Self-test Numbers Appendix B
315 Unformatted card Reminder Memory card is unformatted,
contains an unrecognizable format or
is corrupt. Reformat the card or replace it with a
new card if corrupt. Try again.
316 Write Protected
Card Reminder / File
Transfer Status A write command to the card failed
because the card switch is in the
protected mode. Select write mode by changing the
switch on the top edge of the card.
Try again.
317 File exists.
Cannot overwrite Reminder/File
Transfer Status See message 342. This message only
occurs when the file cannot be
renamed. Change the file name or save to a
new memory card.
323 No application on
PV terminal Reminder/File
Transfer Status You tried to load an application on a
memory card but there is no
application in the terminal. View the Terminal Info screen to see
if an application is loaded in the
terminal.
324 Check card status Reminder/File
Transfer Status
Problem formatting the memory card. Try a new memory card.
325 Unformatted card Reminder Memory card is unformatted,
contains an unrecognizable format or
is corrupt. Reformat the card or replace it with a
new card. Try again.
326 No Card Inserted Reminder You tried to transfer data to/from a
memory card but there is no card in
the card slot. Install a memory card and try again.
327 No files Reminder You tried to transfer a file from the
memory card but there are no files on
the card. Use memory card containing
application (.PVA) files.
330 Write Protected
Card Reminder / File
Transfer Status A write command to the card failed
because the card switch is in
protected mode. Select write mode by changing the
switch on the top edge of the card.
Try again.
332 No application on
PV terminal Reminder/File
Transfer Status You tried to load an application on a
memory card but there is no
application in the terminal. View the Terminal Info screen to see
if an application is loaded in the
terminal.
333 File in use -
Request denied Reminder Attempt to format memory card
containing a file used by the
application. This usually occurs when
an application requires a font file on
the memory card. Format the memory card on a
computer or a PanelView terminal
that does not have an application
loaded.
334 Unexpected card
removal. Please
disconnect card
before removal. Reminder / File
Transfer Status You removed the memory card during
normal operation and did not press
the Disconnect button on the Memory
Card configuration screen. Press the Disconnect Card button to
close the files on the card. When
prompted, remove the card from the
slot and then re-insert the card. Enter
Configuration Mode and press the
Run Mode button.
340 Format erases
entire card:
0 or F1 Abort
1 or F2 - Continue
Warning Operator pressed [F4] Erase / Format
Card on the Memory Card
configuration screen. Enter appropriate response:
0 or F1 to abort
1 or F2 to continue
Error Number Terminal
Messages Type Meaning Recommended Action