Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 137)

Publication 2711-UM014G-EN-P - September 2008 137
Installing the PV300 Micro Terminal Chapter 6
6. Tighten the nuts to a torque of 1.13 Nm (10 lb-in).
Do not overtighten.
ATTENTION
Mounting nuts must be tightened to a torque of 1.13 Nm
(10 lb-in) to provide a proper seal and to prevent potential
damage to the terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to the terminal or
other equipment within the enclosure because of improper
installation. A properly installed terminal has a small gap
between the bezel and enclosure.