Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 112)

112 Publication 2711-UM014G-EN-P - September 2008
Chapter 4 Using a Memory Card
To view the name of the font file used by an application, select
Terminal Info from the Configuration Mode menu.
Because the memory card must remain in the terminal while the
application is running, we recommend that you use the memory card
retainer (Cat. No. 2711-NMCC, 2711-NMCD, 2711-NMCE) to secure the
card in the card slot. The retainer ensures the card is not accidentally
removed or dislodged during terminal operation.
Remove a Memory Card Follow the procedure below to remove a memory card from the
PanelView terminal. Failure to follow this procedure may result in
damage to the card.
1. Select Memory Card from the Configuration Mode menu.
2. Press the Disconnect Card button.
This ensures that all files are closed on the card. A message
prompts you to remove the card from the slot. You can continue
or abort the operation.
3. Press the Continue button.
4. Remove the memory card from the card slot.
On PV1400 terminals, press the Memory Card Eject button.