Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 86)

86 Publication 2711-UM014G-EN-P - September 2008
Chapter 3 Configuring the Terminal
Comm Status Indicator
•
solid fill - normal operating state
•
blinking - no communication established with logic controller
•
no fill - hardware failure
Fault Status Indicator
•
no fill - normal operating state
•
blinking - hardware is functioning but an application is not
loaded or the current application is corrupted.
Exit
Returns to the Configuration Mode menu.
EtherNet/IP Communication
The EtherNet/IP screen lets you display or modify some of the
EtherNet/IP communication settings for an Ethernet PanelView
terminal.
Additional parameters (Gateway Address, DNS Server and Domain
Name, and Timeout values) are set in the Communication Setup
dialog of the PanelBuilder32 software and downloaded with the
application.
IMPORTANT
Settings downloaded with an EtherNet/IP application have
priority over terminal settings and take effect immediately after
the download.
DHCP/BootP Enable:
F16
EXIT
Terminal
Restart
F1
EtherNet/IP
Enabled
Subnet Mask:
Interscan Delay F3: 100
Ethernet Address: ##:##:##:##:##:##:##
Comms
Status
Attached
ms
EXIT
IP Address: 131.200.55.30
255.255.255.0
FW Revision: ######## Serial #: ########