Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 231)

Publication 2711-UM014G-EN-P - September 2008 231
Troubleshooting and Maintenance Chapter 13
Clean the Display Window Follow these steps to clean the display window.
1. Disconnect power from the terminal at the power source.
2. Use a clean sponge or a soft cloth to clean the display with a
mild soap or detergent.
3. Dry the display with a chamois or moist cellulose sponge to
avoid water spots.
Remove Paint and Grease
Remove fresh paint splashes and grease before drying by rubbing
lightly with isopropyl alcohol (70% concentration). Afterward, provide
a final wash using a mild soap or detergent solution. Rinse with clean
water.
Equipment Hose-downs
Be aware that screen objects on touch cell terminals may activate
during equipment hose-downs.
ATTENTION
Use of abrasive cleansers or solvents may damage the window.
Do not scrub or use brushes.
ATTENTION
Because touch terminals have sensitive touch cell regions, it is
possible for screen objects to activate during equipment
hose-downs.