Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 75)

Publication 2711-UM014G-EN-P - September 2008 75
Configuring the Terminal Chapter 3
Restore From Card
Transfers the application under Applications on Card to the terminal.
Any application in the terminal is overwritten.
Save to Card
Saves the current application in the terminal to the memory card.
Erase/Format Card
Erases and formats a 2711-NM11, -12, -13, -14, 15 memory card. This
function deletes all applications on the card. You can’t delete
individual files. Don’t perform this operation on a 2711-NM2xx ATA
card or the card will be inoperable.
Exit
Returns to the Configuration Mode menu.
Configure Communication Select Communication Setup from the Configuration Mode menu to
display or change the communication settings for your PanelView
terminal. The screen that appears depends on the communication
protocol of the terminal.
DH-485 Communication
The DH-485 screen lets you modify or display DH-485 settings for
either a DH-485 or RS-232 PanelView terminal. These are the default
settings.
•
Max Node Address = 31
•
Node Address = 2
•
Communication Rate = 19200
IMPORTANT
Settings downloaded with a DH-485 application take priority
over terminal settings and take effect immediately after the
download.