Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 91)

Publication 2711-UM014G-EN-P - September 2008 91
Configuring the Terminal Chapter 3
Contrast
Increases or decreases the display contrast. The contrast settings range
from 0…10.
Video Mode
Toggles between normal video (dark text/graphics on a light
background) and reverse video (light text/graphics on a dark
background). Changes take effect immediately.
Screen Saver Mode
Mode - Select Timed or Off screen saver. When Timed, the screen
intensity is reduced if user input or a controller screen change is not
received within the time specified in the Screen Saver Timeout
Timeout
Specifies when an inactive screen enters screen saver mode. The
timeout is adjusted in steps with each key press: 5, 10, 15, 20, 25, or
30 minutes.
Reset Video
Resets the display to normal (default settings). If the screen is set to a
non-viewable setting, press the Left and Right arrow keys
simultaneously to enter the configuration mode and enter screen
setup to reset the screen settings.
PanelView 300 Terminal Screen Setup
SCREEN SETUP
F1 Contrast
F8 EXIT
6
F7 MORE
F2 Mode Normal
F3 Reset Video
SCREEN SAVER
F1 Mode
F8 EXIT
Off
F7 MORE
F2 Timeout 10 min.
IMPORTANT
Certain settings may make viewing the screen difficult. Do not
exit this screen until viewing adjustments are acceptable.