Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 201)

Publication 2711-UM014G-EN-P - September 2008 201
Terminal Connections Chapter 12
Connecting to a MicroLogix Controller through an AIC+ Module
This section shows how to connect the RS-232 (DH-485) version of
the PanelView terminal to a MicroLogix controller through an AIC+
Link Coupler.
Connecting a Computer
This section shows how to connect a computer to the RS-232
(DH-485) PanelView terminal for transferring applications.
AIC+ Cat. No.
1761-NET-AIC
MicroLogix 1000, 1200, 1500LSP
PanelView 1000
Belden Cable 9842
RS-232 Communication Cables Cable,
Cat. No. 2711-NC13 Cable, Cat. No.
2711-NC14 Cable, Cat. No. 2706-NC13
Note: On PanelView 550 terminals, pin
8 on the RS-232 connector is pulled
high. Do not use the 2711-NC13 cable.
Catalog No.
1761-CBL-HM02
1761-CBL-AM00
Catalog No. 1747-CP3
Computer
PanelView 1000
Computer
RS-232 Communication Cables Cat.
No. 2711-NC13, 5 m (16.4 ft) Cat.
No. 2711-NC14, 10 m (32.7 ft) Cat.
No. 2706-NC13, 3 m (10 ft)
To Comm1 or Comm2 Port
To RS-232
Communication Port
25-pin to 9-pin
Adapter (if
required)