Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 147)

Publication 2711-UM014G-EN-P - September 2008 147
Installing the PV550 Terminal Chapter 8
Required Tools Other than the tools required to make the PV550 panel cutout, the
tools required for installation are:
•
7 mm (M4) deep well socket wrench or nut driver
•
small slotted screwdriver
•
torque wrench (lb-in)
Mounting Dimensions The illustration below shows mounting dimensions for the PV550
terminals.
PV550 Keypad, Keypad & Touch Screen Terminals
PV550 Touch Screen Terminals
266 mm
(10.47 in.)
167 mm
(6.57 in.)
106 mm
(4.17 in.) 86 mm
(3.39 in.)
Top View
185 mm
(7.28 in.)
152 mm
(6.00 in.) 64 mm
(2.54 in.)
82 mm
(3.20 in.)
Top View