Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 98)

98 Publication 2711-UM014G-EN-P - September 2008
Chapter 3 Configuring the Terminal
Screen Saver Intensity
Adjusts the intensity of the display during screen saver mode. Settings
are 0 (lowest intensity) or 100 (highest intensity). 0 is recommended
to prolong the display life.
Reset Video
Resets the display to normal video (default settings).
On keypad terminals, the reset video [F15] key is also active on the
Configuration Mode menu. If the screen is non-viewable, press the
Left and Right arrow keys simultaneously. Then press reset video
[F15] to reset the screen.
Exit
Returns to the Configuration Mode menu.
PanelView 1400 Color Terminal Screen Setup
Screen Saver Mode
Sets the screen saver to Timed or Off. When Timed, the screen
intensity is reduced if user input or a controller screen change is not
received within the time specified in the Screen Saver Timeout box.
Screen Saver Timeout
Specifies when an inactive screen enters screen saver mode. The
timeout is adjusted in 5 minute increments with each key press, from
5…30 minutes.
IMPORTANT
Certain settings may make viewing the screen difficult. Do not
exit this screen until viewing adjustments are acceptable.
SCREEN SETUP
SCREEN
SAVER
DEGAUSS
Mode Auto
Normal
Intensity
Enabled 100 Off
5 min.
100
Intensity
Timeout
F1
F2
F3
F4 F8
Reset
Video
## 0# :
Hour Minute
F5 F6 F15
Manual
Degauss
F7
F16
EXIT ALIGN
Touch Screen only
GRID
TOUCH