Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 117)

Publication 2711-UM014G-EN-P - September 2008 117
Running Applications Chapter 5
List Keys
Touch screen terminals require list keys on the screen to move the
cursor in a control list and select entries. The following table shows
the list keys.
Cursor-piloted Control Lists
On a piloted control list, some items are under controller operation
only. In addition, some items may be designated as inactive. You
cannot select controller items or inactive items. In both cases, the
cursor is hollow when you select the item.
List Key Type Description
Move Up Moves the cursor to the previous item in the list.
Move Down Moves the cursor to the next item in the list.
Home Moves the cursor to the first item in the list.
End Moves the cursor to the last item in the list.
Page Up Moves the cursor up one page in a scrolling list.
Page Down Moves the cursor down one page in a scrolling list.
Backspace Returns the cursor to the currently highlighted
selection.
Enter Confirms a selection and sends the value to the
controller if Write on Enter was configured for the
control list.
State 1
State 4
State 5
State 1
State 2
State 3
State 4
State 5
State 2
State 3
State 1
State 5
State 2
State 3
State 4
State2
Cursor at state 2,
an active state Cursor at inactive state 3,
Cursor changes and highlight
remains in original position Cursor at inactive state 3,
Cursor changes and highlight
remains in original position Cursor at active state 4,
Cursor changes back and
highlight moves to selection
Active State
Inactive State
Active State