Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 150)

150 Publication 2711-UM014G-EN-P - September 2008
Chapter 8 Installing the PV550 Terminal
Install the PV550 Terminal
in a Panel Follow these step to install the PV550 terminal in a panel.
1. Cut an opening in the panel by using the panel cutout template
provided with the terminal and remove any sharp edges or
burrs.
2. Make sure the terminal sealing gasket is properly positioned on
the terminal, particularly around the mounting studs as shown.
This gasket forms a compression type seal. Do not use sealing
compounds.
3. On the keypad and keypad and touch screen terminals, secure
the ends of the legend strips to the legend strip adhesive.
4. Place the terminal in the panel cutout.
5. Verify that the opening is the proper size to clear the bezel and
to allow the gasket to contact the panel.
6. On the keypad and keypad and touch screen terminals, position
the ends of the legend inserts behind the panel cutout.
7. Install the self-locking nuts hand tight.
ATTENTION
•
Disconnect all electrical power from the panel before making the
cutout.
•
Make sure the area around the panel cutout is clear.
•
Do not allow metal cuttings to enter any components that may
already be installed in the panel.
•
Failure to follow this warning may result in personal injury or damage
to the panel components.
Sealing Gasket
Adhesive Legend Strip (Keypad and Keypad and Touch Screen
Terminals only)