Yaskawa MP2000 - Manual (Page 81)

TECHNICAL NOTE
<MOD_ENG> Block error condition:
The following table outlines several situations that may cause an error, and will turn on
the blocks “Error” output bit. The block “Error” output will cleared if the EXECUTE bit
goes low.
Fault bit Cause Note
inOK
AB00000D Machine Cycle
input is out of
range inOK must be high if enable is on
or an error will occur. MCHNCYCL
must be in range for this bit to be
on. Sets RDA Error ID (MW30181)
bit 3.
msSelect
AB00000E
M-S-PAIR
input
value out of
range
msSelect must be high if enable is
on or an error will occur. M-S-PAIR
must have a value from one to ten
for this bit to be on. Sets RDA Error
ID (MW30181) bit 3.
<MOD_ENG> Working Registers
This table outlines the data in the eight registers used by the function block. There is
not usually any need for the user to access any of these bits directly.
Register No TYPE Name Content
AW00000
Bit 0 IN enable ENABEL input (XB000000)
Bit 1 IN reset RESET input (XB000002)
Bit 2 IN posOut Reserved
Bit 3 IN negOut Reserved
Bit 4 OUT endofTravl Directly controls YB000001 (ENDPRFL Output)
Bit 7 OUT running Directly controls YB000000 (RUNNING Output)
Bit 9 OUT error Directly controls YB000002 (ERROR Output)
Bit A Working oneshotA Reserved
Bit B Working firstPass Rising edge of EXECUTE (XB000001)
Bit D Working inOK Verifies that the MCHNCYCL input (XW00002) is in range.
Bit E Working msSelect Verifies that the M-S-PAIR input (XW00001) is in range.
AW00001 Working store_i Reserved
AW00002 Working pairvalue M-S-PAIR input (XW00001) - 1.
AL00003 Working o modpos_o Reserved
AL00005 Working pos Modulated data being stored
AL00007 Working lscratch Reserved.
AL00009 Working offset Reserved
AL00011 Working modData Modulated data as read back from the RDA.
AW00013 Working Revision Revision Level of the function block.
File: MP2000_IndividualFunctionDocument_RevC 81/168
Doc Number: eng.MCD.05.101
11/17/2005