Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 29)

3.1 Ladder Program Design Procedures
3-2
3.1 Ladder Program Design Procedures
This section describes the design procedures for ladder programs as outlined below.
ΠThe above flowchart is an example of the ladder program design process. Settings to interface the external devices
must be completed to use programs on the actual system.
e Creating a Project
Create a project before you start ladder program
development.
c Preparation for Devices to Be Connected
Assemble and wire all devices to be connected.
Install MPE720 on a PC.
d System Startup
Perform self configuration and start the system.
g Transferring Ladder Programs
Transfer the ladder programs that you created to
the MP2000-series Machine Controllers.
h Checking the Operation of the Ladder Programs
Check the operation of the ladder programs.
i Saving the Ladder Programs to Flash Memory
Save the debugged ladder programs to flash memory.
f Creating Ladder Programs
Enter the ladder programs in the Ladder Editor.
Refer to 3.1.1 Connecting the Hardware.
Refer to 3.1.2 Installing MPE720 Version 6.
Refer to 3.1.3 Communications Settings.
Refer to 3.1.4 System Startup.
Refer to 3.1.5 Creating a Project.
Refer to 3.1.6 Creating Ladder Programs.
Refer to 3.1.7 Transferring Ladder Programs.
Refer to 3.1.8 Checking the Operation of the Ladder
Programs.
Refer to 3.1.9 Saving the Ladder Programs to Flash
Memory.