Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 395)

B.2 Converting CP (Previous) Ladder Programs to New Ladder Programs
B-3
CP
(Previous) Ladder Instructions and New Ladder Instructions
AppB
B.2 Converting CP (Previous) Ladder Programs to New Ladder
Programs
You can use the CP ladder program conversion function on MPE720 version 6 to convert CP ladder programs to
new ladder programs. When converting a program, DWG properties and comments in the program will be con-
verted at the same time.
You must be offline to convert CP ladder programs. (You cannot convert CP ladder programs while connected to
the Machine Controller.) Refer to 3.6 Converting CP Ladder Programs to Ordinary Ladder Programs in the
Engineering Tool for MP2000 Series Machine Controller MPE720 Version 6 User’s Manual (SIEP C880700 30)
on converting CP ladder programs.
„
Procedure to Convert CP Ladder Programs
1.
Select a program folder (High-speed, Low-speed, Start, Interrupt, or Function) or select a program that
contains programs of the lower hierarchical levels. Then, right-click the selected folder or program and
select Conversion of CP ladder from the pop-up menu.
When the selected program contains programs of lower hierarchical levels, the following message will appear
asking for confirmation.
Conversion: Click this button to convert the current program and all lower level programs to new ladder pro-
grams.
Select: Click this button to display the Conversion of CP ladder Dialog Box. See step 2 for details on setting.
Cancel: Click this button to cancel program conversion.