Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 41)

3.1 Ladder Program Design Procedures
3.1.9 Saving the Ladder Programs to Flash Memory
3-14
3.1.9 Saving the Ladder Programs to Flash Memory
Use the following procedure to save the data from the RAM in the MP2000-series Machine Controller to the flash
memory in the MP2000-series Machine Controller.
1.
Select Transfer − Save to flash from the following window.
2.
Click the Start Button.
3. Click the CPU STOP Button. The transfer will start.
4. Click the Yes Button in the following dialog box. The Machine Controller will switch to RUN Mode.