Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 77)

5.2 Relay Circuit Instructions
5.2.3 10-ms ON-Delay Timer (TON[10ms])
5-8
( 3 ) Programming Example
In the following programming example, the set value of the TON instruction is 50, and the count value is stored in the
DW00001 register.
The DB000001 coil will turn ON after the DB000000 relay stays ON for 500 ms.
The timing chart is shown below.
DB000000
DB000001
ON
OFF
ON
OFF
DW00001
50
0
500 ms - Ts
(Ts: Scan time set value)