Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 64)

4.6 Transferring Data
4-23
Programming
4
4.6 Transferring Data
You can perform one of the four operations that are shown in the following figure to transfer data.
c Writing Data to a Machine Controller
You can transfer the project data that was created offline to RAM in the Machine Controller.
d Reading Data from the Machine Controller.
You can transfer data from the Machine Controller to a project on the hard disk of the PC.
e Reading Data from and Writing Data to Projects
You can transfer data between projects on the hard disk of the PC.
f Saving Data to Flash Memory
You can transfer the data in RAM in the Machine Controller to flash memory.
Always save the data to flash memory after you transfer it to the MP2000-series Machine Controller.
Failure to save the data to flash memory will result in losing the data that was transferred when the power is
turned OFF and ON again, causing the Machine Controller to run on the data that was last saved in the flash
memory.
RAM
MP2000-series
Machine Controller
Hard disk in PC
Project
Project
MPE720 version 6
c Data can be written to
the Machine Controller.
d Data can be read from
the Machine Controller.
e Data can be read from
and written to projects.
Flash memory
f Data can be saved
to flash memory.
IMPORTANT