Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 36)

3.1 Ladder Program Design Procedures
3.1.7 Transferring Ladder Programs
3-9
Ladder Program Development Flow
3
3.1.7 Transferring Ladder Programs
Use the following procedure to transfer the ladder program to the MP2000-series Machine Controller. This procedure
is not necessary if you created the ladder program online.
1.
Select Communications Setting on the Start Tab Page.
2.
Select the desired communications port in the Communications Setting Box, and then click the Con-
nection Button.
3.
Wait for the MPE720 to go online, and then select Transfer − Write into controller.