Yaskawa MP900 Series Ladder Programming Manual - Manual (Page 31)

3.1 Ladder Program Design Procedures
3.1.2 Installing MPE720 Version 6
3-4
3.1.2 Installing MPE720 Version 6
Install MPE720 version 6 on a PC.
Refer to the Engineering Tool for MP2000 Series Machine Controller MPE720 Version 6 User’s Manual (SIEP
C880700 30) for the installation procedure.
3.1.3 Communications Settings
After you install MPE720 version 6 on the PC, set up communications between the MP2000-series Machine Controller
and the PC.
Refer to the Engineering Tool for MP2000 Series Machine Controller MPE720 Version 6 User’s Manual (SIEP
C880700 30) for the communications setup procedure.
3.1.4 System Startup
Set up the system by performing self configuration. Self configuration automatically recognizes the Modules that are
installed in the MP2000-series Machine Controller and the devices that are connected through the MECHATROLINK
connector. This allows you to quickly and easily set up the system. You can perform self configuration by using the
DIP switch on the Machine Controller or by using the MPE720.
Refer to the user’s manual for your Machine Controller for details on self configuration.